- 商品详情
PRODUCT DESCRIPTION
KSD314-T series thermostat belongs to the Voltage maintained thermal cut-out. It is characterized in that after reaching the operating temperature, the thermostat will be disconnected and remain disconnected until the external power supply is cut off. Compared with the manually reset product (KSD314-R), it can provide more reliable and reusable protection functions; it is suitable for electric appliances with high reliability requirements for safety protection, especially suitable for electric heaters. Use with overheat protector.
The product contacts are single-pole single-throw (SPST), and the housing is made of high-temperature resistant resin material with a maximum operating temperature of 140C. The pressure rating is basic insulation, and certain additional measures can be taken to achieve a reinforced insulation level. The standard load nature is purely resistive, providing micro-disconnection.
BASIC TECHNICAL PARAMETERS
Sub-series | Action type | Switch type | Rated current (resistive load) | Operating temperature OT. |
KSD314-V | Auto reset | SPST、NC/NO | 35A | 30～180°C（TUV）30～140°C（UL） |
KSD314-R & KSD314-R-C | Manual reset | SPST、NC | 35A | 40～140°C |
KSD314-N | SOD | SPST、NC | 35A | 40～140°C |
KSD314-T | PTC cutoff,Voltage maintain type | SPST、NC | 35A | 55～140°C |
KSD314-Q | Double functions-Auto reset and one shot type | SPST、NC | 45A | 30～100°C |
KSD314-F （developing） | SPDT type Auto reset | SPDT | 25A | 30～140°C |
KSD314-W （developing） | Auto reset with thermal compensation | SPST、NC | 25A | 30～140°C |
Tmax：
OT：70°C | OT:71~180°C | |
140°C(L) 170°C (S) | 205°C (L) 235°C (S) |
L： Long term
S：Less than 15 min
DIMENSION OF THE MAIN BODY
SAFETY CERTIFICATE
OT | Life cycles | 250V/125V 35A |
55～140°C | 10,000 | TUV/UL |
INSTALLATION AND DIRECTION FOR USE
| Installation and use instructions: |
| 1. Grounding method: Connected to the grounding metal parts of the equipment through the metal casing of the thermostat. 2. The thermostat shall be operated in a general indoor environment where the relative humidity of the air is not more than 90%, no corrosive gas, no flammable gas and conductive dust. 3. When the temperature controller is in contact with the temperature, the cover should be placed close to the heat-generating part of the controlled appliance, and the thermal surface of the cover should be coated with thermal grease or other similar heat-conducting medium. 4. When the temperature controller is exposed to liquid or steam, it is recommended to use a stainless steel cover and a reliable leak-proof measure to prevent liquid from seeping into the insulation of the thermostat. 5. It is not possible to collapse or deform the top of the cover to avoid changes in operating temperature or other properties. 6. Do not allow liquid to penetrate inside the thermostat! The housing must be protected from excessive forces to prevent cracking; the housing should be kept clean to prevent contamination of conductive materials to prevent short-circuit breakdown due to reduced insulation. 7. The terminal cannot be bent during use, otherwise the reliability of the electrical connection will be affected. |
